Brother BM2600 machine woes

I'm about to have a mental breakdown at my sewing machine. I am just trying to sew wipes - 2 bits of fabric sewn together. Sounds simple enough, right? But the blimmin thread breaks ALL THE TIME! If I manage to make it round one wipe only rethreading 6 times I am doing well

Seriously, WTF? I've been thru my manual and done all the "troubleshooting" it suggests for thread breaking. I've cleaned under the sewing plate (and managed to knock off the presser foot in the process which took half an hour to get out lol), have loosened the upper thread tension, turned the thread round to face the other way etc etc.
It also skips stitches but that's more so with zigzag stitch which I'm not doing right now, but have followed all the instructions for that too to no avail. My needle is sharp - it was replaced recently, and it is inserted properly, i checked it again. ARRRRRRRRRRRGH!!!

Does anyone else have these problems? Is it just that this machine is a piece of shyte, or perhaps it's me?! I'm using thread from Greenbeans which I always have done, is this thread not very good? I like it that it's only $2something for $1000m as opposed to much more expensive thread from Spotlite or other shops. But am willing to buy the expensive kind if it's the thread that's the problem.

I'm about ready to give up, but I have about 10 wipes to finish, plus 12 nappies (which cause even more problems as that's THREE layers of material which the machine copes with even less )

HELP!

I've also had problems with this machine and the thread tension. After trying everything with a skirt I was sewing I decided to buy a better quality thread and the problem was instantly solved.

Right I'm gonna buy some expensive thread tomorrow!! I am seriously going mental lol, think I'll have a break from sewing till I have new thread to try out

I have a Brother nx600 but haven't had that problem, it has auto tensioning though. My old singer used to snap threads, my only advice would be get good quality thread, make sure you have the same thread through the top & on the bobbin, make sure you're using the right needle for the fabric too. I'd ring the hotline number if the better thread doesn't help.

whenever i have this problem, i just change my needle and its fine. i have a Brother BC-2500.

also what type of thread do you use? I only use gutermann because anything else breaks constantly, need to use good quality thread. even using the organic cotton thread from gutermann is terrible. have to use the standard polyester stuff when i can. if you can afford it, dont buy the cheaper thread. gutermann is $3 for a 100m (110 yards) roll. think i pay about $10-$11 for a 500m roll?


also pull the thread right out and rethread from the start, not just trim and rethread the needle. (which im sure you already have)



if changing the needle, rethreading and using a good quality thread doesnt work, may be time for a service. also - make sure you are using the correct needle (ball point for stretch fabrics, standard/universal for non-stretch regular fabrics. (moving up to sharps for satins etc)



hope you figure it out breaking thread is my pet hate lol.